*****REQUIRED*****

Serial Connection for console access to the device

*****INSTRUCTIONS*****
The config template provided below will setup a registration based SIP Trunk on an ADTRAN 904 with a PRI out. It does not include any of the networking settings which are unique to each installation.

Before using this template you must find and replace the following values:

123USER with your Account Number (The SIP Username).
456PASS with your Service Password.

Note that when quotations ("") exist must remain in use. For example "13055551212" and "1secret2"

*****START YOUR COPY BELOW THIS LINE*****

interface eth0/1
media-gateway ip primary
interface t1 0/1
tdm-group 1 timeslots 1-24 speed 64
no shutdown
!
interface pri 1
description pri 1
isdn name-delivery proceeding
connect t1 0/1 tdm-group 1
role network b-channel-restarts enable
no shutdown
!
isdn-group 1
connect pri 1
!
ip sip
ip sip udp 5060
no ip sip tcp
!
voice feature-mode network
voice forward-mode network
!
voice spre 1 *XX&
!
voice dial-plan 1 local NXX-NXX-XXXX
!
voice trunk T01 type sip
description "SIPIN"
sip-server primary sbc.ringlogix.com
registrar primary sbc.ringlogix.com
authentication username "123USER" password "456PASS"
max-number-calls 23
register 123USER
!
voice trunk T02 type isdn
description "PRIOUT"
resource-selection linear descending
connect isdn-group 1
rtp delay-mode adaptive
!
voice grouped-trunk DIALPLAN
trunk T01
trunk T02
accept NXX-NXX-XXXX cost 0
accept 1-NXX-NXX-XXXX cost 0
accept 1-800-NXX-XXXX cost 0
accept 1-888-NXX-XXXX cost 0
accept 1-877-NXX-XXXX cost 0
accept 1-866-NXX-XXXX cost 0
accept 1-855-NXX-XXXX cost 0
accept 011-$ cost 0
accept 411 cost 0
accept 611 cost 0
accept 911 cost 0
accept 0-NXX-NXX-XXXX cost 0
accept 10-10-XXX-$ cost 0
accept $ cost 0
reject NXX-976-XXXX
reject 1-900-NXX-XXXX
reject 1-976-NXX-XXXX

!
ip sip qos dscp 46
!
ip rtp udp 15000
!