Cisco SPA112 Basic Configuration Guide
Find the IP address of the Cisco SPA-112.
- Connect an analog phone to the first FXS port.
- From the analog phone dial **** (four asterisks).
- Then press 110# to determine the IP address (the system will speak the address, EXAMPLE: 192.168.1.130).
Once logged into the SPA-112 do the following to configure the phone.
Under the Voice Tab select the Line you will configure these services on.
1. Set ‘NAT Keep Alive’ to Yes
2. Enter feature code *98 for Mialbox ID
3. Enter in the host address for the Proxy. sbc.ringlogix.com.
4. Enter the Ext-Name of the Account
5. Enter the Account Service Password
6. Enter the Account ID for User ID and Auth ID. Set Use Auth ID to Yes.
7. Set Preferred Codecs to G729a
8. Set Second Preffered to G711u
Under the Network Setup select the Time Settings Sub Tab
9. Set your proper Time Zone
10. Enter us.pool.ntp.org
Related Articles
Cisco SPA8000 Configuration Guide
Find the IP address of the Cisco SPA8000. Connect an analog phone to the first FXS port. From the analog phone dial **** (four asterisks). Then press 110# to determine the IP address (the system will speak the address, EXAMPLE: 192.168.1.130). Once ...Netgen HX40xE Fax ATA Configuration Guide
This article will show you how to configure the Netgen Fax ATA for use on the RingLogix T38 IP Fax platform. Netgen HX40xE Configuration Guide 1. Power on the device and connect the PC port to your internet switch or router. 2. The device will ...3CX Configuration Guide
RingLogix is proud to be part of a select group of Providers that have been officially tested and certified by 3CX. Note: Before trying to configure your 3CX phone system please make sure you have already created a customer and activated a SIP Trunk ...Grandstream UCM61XX Configuration Guide
To log into the PBX, use the IP address found on the LED screen of the UCM. Use a web browser and go to that address. Since the web GUI is using https, it will warn you that the "site's security certificate is not trusted" or you will see an SSL ...Asterisk Distribution Configuration Guide
For Asterisk setups the following needs to be done. Find the Asterisk version Modify extensions_custom.conf Add SIP Trunk For this example we will be using Elastix. Finding Asterisk Verison Use Putty or use the Asteris-CLI asterisk -r core show ...