Knowledgebase
20Important & Helpful Info 2Sales & Quoting Tools 9Add Customers & Services 7TeamMate 8Customer Billing 13Phone Numbers 108Hosted PBX 15SIP Trunking 8Microsoft Teams Direct Routing 9IP Fax 2Audio Conferencing 1Other Services 16Platform Settings 7Platform Reports 1010DLC - TCR Messaging Compliance 4VoIP Troubleshooting Tools 25Router & Network Help 1API Access 8Release Notes
Knowledgebase: Router & Network Help > Generic Router Help
Disable SIP ALG in Cyberoam
Posted by , Last modified by Albert Diaz on 05 May 2015 03:44 PM
SIP support in Cyberoam

Applicable Version: 10.00 onwards

Cyberoam supports Session Initiation Protocol (SIP) for multimedia communication such as VoIP.  

Cyberoam SIP Module is enabled by default and provides the following functionalities for SIP traffic:

•         Works on UDP port 5060.

•         NATing of local IP addresses to public IP addresses.

•         Enables a dynamic voice channel by setting up an expected voice connection in the Firewall.

The administrator can disable the SIP module by following the steps mentioned below: 

1.    Logon to the CLI console and select option 4. Cyberoam Console from the Main Menu list.

2.    Execute the following command:

 console> cyberoam system_modules sip unload  
 
 

Note:


To load SIP module again, execute the following command at the console prompt:

 

             
 
 

                                                                                   Document Version: 1.2 - 30 October, 2014


Attachments 
 
 sip_support_in_cyberoam.pdf (189.51 KB)
(2 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).