How to Disable SIP ALG on a Mikrotik
Posted by , Last modified by Albert Diaz on 05 May 2015 04:03 PM

SIP ALG Explained

Many of today's commercial routers implement SIP ALG (Application-level gateway), coming with this feature enabled by default. While ALG could help in solving NAT related problems, the fact is that many routers' ALG implementations are wrong and break SIP.

There are various solutions for SIP clients behind NAT, some of them in client side (STUN, TURN, ICE), others in server side (Proxy RTP as RtpProxy,MediaProxy). ALG works typically in the client LAN router or gateway. In some scenarios some client side solutions are not valid, for example STUN with symmetrical NAT router. If the SIP proxy doesn't provide a server side NAT solution, then an ALG solution could have a place.

An ALG understands the protocol used by the specific applications that it supports (in this case SIP) and does a protocol packet-inspection of traffic through it. A NAT router with a built-in SIP ALG can re-write information within the SIP messages (SIP headers and SDP body) making signaling and audio traffic between the client behind NAT and the SIP endpoint possible.

SIP ALG problems

The main problem is the poor implementation at SIP protocol level of most commercial routers and the fact that this technology is just useful for outgoing calls, but not for incoming calls:

  • Lack of incoming calls: When a UA is switched on it sends a REGISTER to the proxy in order to be localizable and receive incoming calls. This REGISTER is modified by the ALG feature (if not the user wouldn't be reachable by the proxy since it indicated a private IP in REGISTER "Contact" header). Common routers just mantain the UDP "conntection" open for a while (30-60 seconds) so after that time the port forwarding is ended and incoming packets are discarded by the router. Many SIP proxies mantain the UDP keepalive by sending OPTIONS or NOTIFY messages to the UA, but they just do it when the UA has been detected as natted during the registration. A SIP ALG router rewrites the REGISTER request so the proxy doesn't detect the NAT and doesn't mantain the keepalive (so incoming calls will be not possible).
  • Breaking SIP signalling: Many of the actual common routers with inbuilt SIP ALG modify SIP headers and the SDP body incorrectly, breaking SIP and making communication just impossible. Some of them do a whole replacing by searching a private address in all SIP headers and body and replacing them with the router public mapped address (for example, replacing the private address if it appears in "Call-ID" header, which makes no sense at all). Many SIP ALG routers corrupt the SIP message when writting into it (i.e. missed semi-colon ";" in header parameters). Writting incorrect port values greater than 65536 is also common in many of these routers.
  • Dissallows server side solutions: Even if you don't need a client side NAT solution (your SIP proxy gives you a server NAT solution), if your router has SIP ALG enabled that breaks SIP signalling, it will make communication with your proxy impossible.

 

Mikrotik SIP ALG is called a SIP Helper and is located under /IP>Firewall>Service ports

To disable, run this command from the terminal:

/ip firewall service-port disable sip

Or from winbox just navigate to IP>Firewall and then click on the Service Ports tab and disable it through the GUI.

Disable ALG

(37 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).