Knowledgebase : SIP Trunking > Device Configuration
RingLogix is proud to be part of a select group of Providers that have been OFFICIALLY TESTED AND CERTIFIED BY 3CX. In addition, RingLogix was recently added to 3CX's built-in VOIP PROVIDER template feature which pre-configures several important trunk s...
*****REQUIRED***** Serial Connection for console access to the device *****INSTRUCTIONS***** The config template provided below will setup a registration based SIP Trunk on an ADTRAN 904 with a PRI out. It does not include any of the networking settin...
For Asterisk setups the following needs to be done. * Find the Asterisk version * Modify extensions_custom.conf * Add SIP Trunk For this example we will be using Elastix.  -------------------------  FINDING ASTERISK VERISON Use Putty or use t...
Please find attached the 3NG Networks - Avaya IP Office 9.1 - SIP Trunking Configuration documentation.
FIND THE IP ADDRESS OF THE CISCO SPA-112. * Connect an analog phone to the first FXS port. * From the analog phone dial **** (four asterisks). * Then press 110# to determine the IP address (the system will speak the address, EXAMPLE: 192.168.1.130...
Find the IP address of the Cisco SPA8000. * Connect an analog phone to the first FXS port. * From the analog phone dial **** (four asterisks). * Then press 110# to determine the IP address (the system will speak the address, EXAMPLE: 192.168.1.130...
To log into the PBX, use the IP address found on the LED screen of the UCM. Use a web browser and go to that address. Since the web GUI is using https, it will warn you that the "site's security certificate is not trusted" or you will see an SSL error dep...
TRUNK CONFIG SETTINGS FOR IPITOMY PBX    
This article will show you how to configure the Netgen Fax ATA for use on the RingLogix T38 IP Fax platform. NETGEN HX40XE CONFIGURATION GUIDE 1. POWER ON the device and connect the PC PORT to your internet switch or router. 2. The device will automatic...
To access the Yeastar MyPBX's web GUI, please change network settings to be on the 192.168.5.X subnet. LOGGING IN & CHANGING PASSWORD * From a web browser go to 192.168.5.150 * Log in using the default * User Name: ADMIN * Password: PASSWORD ...